Installation Instructions
2REMOVE EXHAUST ADAPTOR
If exhausting/venting using the 31⁄4″ x 10″ rectangular
Remove the exhaust adaptor from the inside of the hood. Set it aside along with its mounting screws.
31⁄4″ x 10″ 
rectangular exhaust adaptor
and screws
3REMOVE FILTER
Remove the shipping tape holding the metal grease filter in place. Pull down on the center of the front edge of the filter. The filter will then slip out of the retaining tabs on the back.
Metal grease filter
4REVERSE THE BAFFLE FOR
DUCTED INSTALLATIONS ONLY
(JV347 and JV367 models)
If the hood is to be recirculated, skip to the next step. Remove the baffle from the top of the hood.
“VENTED” is visible
5REMOVE WIRING COVER
Remove the wiring cover from inside the hood. Set the cover and its mounting screw aside.
Wiring cover
6REMOVE WIRING KNOCKOUT
Remove either the top or the back wiring knockout as needed and install an approved strain relief clamp.
Back knockout |
|
Top knockout |
|
Strain relief | Strain relief |
clamp | clamp |
11
