GE 164D4290P393 Instructions, Operating, Charcoal Filter-Recirculating Installations Only, Safety

Charcoal Filter–Recirculating Installations Only

Safety

Replaceable charcoal filter

NOTE: DO NOT rinse, or put charcoal filters in an automatic dishwasher.

The charcoal filter cannot be cleaned. It must be replaced. Order filter no. WB02X10700. Replacement filters can be ordered from your GE supplier.

If the hood is not vented to the outside, the air will be recirculated through a disposable charcoal filter that helps remove smoke and odors.

The charcoal filter should be replaced after 6 to 12 months (depending on hood usage).

To remove:

Pull down on the center of the front edge of the filter. The filter will then slip out of the retaining tabs on the back.

To replace:

Slip the back edge of the filter into the retaining tabs and push the front edge up until it snaps into place.

Instructions

Operating

Painted Surfaces

Do not use steel-wool pads or other abrasive cleaners. They will scratch the surface.

Clean grease-laden surfaces of the hood frequently. To clean the hood surface, use a hot, damp cloth with a mild detergent suitable for painted surfaces. About one tablespoon of ammonia may be added to the water. Use a clean, hot, damp cloth to remove soap. Dry with a dry,

clean cloth.

NOTE: When cleaning, take care not to come in contact with filters and other non-enameled surfaces.

CAUTION: When cleaning the hood surfaces, be certain that you do not touch the light bulb with moist hands or cloth. A warm or hot light bulb may break if touched with a moist surface. Always let the light bulb cool completely before cleaning around it.

Instructions

Installation

Hood Light

CAUTION: Let the light bulb cool completely before removing.

A warm or hot bulb may break if touched with a moist cloth or hand.

Remove the bulb and replace with

Light coveran ordinary screw-base light bulb, not more than 60 watts.

To remove the light cover (on some models):

•Press the sides with two fingers until the side prongs are released.

•Lift the light cover and slide it toward you in one motion.

To replace the light cover:

•Insert the prong located at the end of the cover into the top opening.

•Gently push the cover up and press the sides to fit the side prongs into the side openings.

•Release and the cover will lock in position.

Instructions

Consumer Support

5