GE 164D4290P393 Remove Duct Knockout, For 7″ Round Vertical Ducted Discharge Installations only

Installation Instructions

7REMOVE DUCT KNOCKOUT

If recirculating, non-vented ductless (JN327 and RN328, and optional for JV347 and JV367 models only), skip to Step 10 D and proceed.

Using a flat blade screwdriver, remove the appropriate duct knockout from the top or back of the hood.

8FOR 31⁄4″ X 10″ RECTANGULAR

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Attach exhaust adaptor/damper over the appropriate knockout opening (for vertical or horizontal, depending on installation) with two exhaust adaptor screws. Make sure damper pivot is nearest to top/back

31⁄4″ x 10″ Rectangular vertical discharge. Remove top rectangular duct knockout only.

7 ″ Round vertical discharge. Remove circular duct knockout only.

31⁄4″ x 10″ Rectangular horizontal discharge. Remove rear rectangular duct knockout only.

edge of hood. Remove tape from damper flap.

	Exhaust adaptor/damper
Up to 1″ side-to-	(vertical discharge position)	Tape
side adjustment

Pivot

Top/back edge

(depending on

installation)Exhaust adaptor/damper (horizontal discharge position)

NOTE: The exhaust adaptor/damper can be installed up to 1 inch on either side of the hood center to accommodate off-center ductwork. In extreme off- center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

9FOR 7″ ROUND VERTICAL

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Bend up the duct alignment ears in preparation for later attachment of the 7″ duct.

Attachment ear tabs

12