Water Filter

36” All-Refrigerator and All-Freezer Units

About the GE® MWF water filter cartridge

Water filter cartridge

The water filter cartridge is located in the back upper right corner of the refrigerator compartment.

Installing the filter cartridge

Fill the replacement cartridge with water from the tap to allow for better flow from the dispenser immediately after installation.

When to replace the filter on models with a replacement indicator light

There is a replacement indicator light for the water filter cartridge on the dispenser. This light will turn orange to

tell you that you need to replace the filter soon.

The filter cartridge should be replaced when the replacement indicator light turns red or if the flow of water to the dispenser or icemaker decreases.

When to replace the filter on models without a replacement indicator light

The filter cartridge should be replaced every six months or earlier if the flow of water to the dispenser or icemaker decreases.

Line up the arrow on the cartridge and the cartridge holder. Place the top of the new cartridge up inside the holder.

Do not push it up into the holder.

Slowly turn it to the right until the filter

 

cartridge stops. DO NOT OVERTIGHTEN.

Cartridge

As you turn the cartridge, it will

Holder

 

ridge

automatically raise itself into position.

older

The cartridge will move about a ½ turn.

 

Run water from the dispenser for 1-1/2 gallons (about three minutes) to clear the system and prevent sputtering.

Press and hold the RESET WATER FILTER pad (on some models) on the dispenser for three seconds.

NOTE: A newly installed water filter cartridge may cause water to spurt from the dispenser.

Removing the filter cartridge

If you are replacing the cartridge, first remove the old one

by slowly turning it to the left. Do not pull down on the cartridge. A small amount of water may drip down.

CAUTION: To reduce the risk associated with property damage due to water leakage, read and follow instructions before installation and use of this system. Installation and use MUST comply with all state and local plumbing codes.

Filter bypass plug

You must use the filter bypass plug when a replacement filter cartridge is not available. The dispenser and the icemaker will not operate without the filter or filter bypass plug.

Filter Bypass

Filter Bypass

ter

Plug

Plug

 

 

ss

SmartWater

Water by Culligan

 

 

ug

To use the filter bypass plug on Water by Culliganmodels,

you must first remove the filter adaptor from the cartridge holder by turning it to the left.

WARNING

To reduce the risk associated with choking, do not allow children under 3 years of age to have access to small parts during the installation of this product. The disposable filter cartridge should be replaced every

6 months at the rated capacity, or sooner if a noticeable reduction in flow rate occurs.

For the maximum benefit of your filtration system, GE recommends the use of GE-branded filters only. Using GE-branded filters in GE and Hotpoint® refrigerators provides optimal performance and reliability. GE filters

meet rigorous industry NSF standards for safety and quality that are important for products that are filtering your water. GE has not qualified non-GE-branded filters for use in GE and Hotpoint refrigerators and there is no assurance

that non-GE-branded filters meet GE's standards for quality, performance and reliability.

If you have questions, or to order additional filter cartridges, visit our website at www.gewaterfilters.com or call GE Parts and Accessories, 800.626.2002.

Customers in Canada should consult the yellow pages for the nearest Camco Service Center.

10

Page 10
Image 10
GE 224D2602P001 Water Filter, Water filter cartridge, Installing the filter cartridge, Removing the filter cartridge