GE 29897 manual Wall Mounting the Phone

WALL MOUNTING THE PHONE

1.Carefully turn the handset hook 180° with a coin or screwdriver until it points upward. You need to do this so that the handset doesn’t fall out of the base.

2.Plug the coiled cord into the handset. Plug the other

end into the jack on the side of the base.

3. Place the handset in the base.

4. Carefully turn the phone over. Detach the mounting bracket from the two sets of top grooves by pressing the tabs in. Pull the bracket from the phone and turn it around so that it looks like the diagram. Gently press the bracket into the two sets of bottom grooves until it snaps into place.

5.Plug the line cord into the jack on the back of the base. Wrap the extra line cord, if any, around the hooks provided on the bottom of the unit.

6.Feed the short line cord through the grooves provided so that the bottom of the phone is flat and ready to mount on the wall.

7.Connect the other end of the line cord into the wall phone jack.

8.Connect the small end of the power supply into the POWER 7.5V AC jack on the back of the answerer. Plug the other end into an AC power outlet. The unit beeps once and is ready for setup or to answer calls with the default greeting and settings.

9.Slip the mounting holes of the base (on bottom of unit) over the wall plate posts and slide the base down until the phone is firmly in place.

NOTE: The phone automatically defaults to touch-tone dialing. To change to pulse (rotary) dialing, see “Setting the Dialing Mode.” If you don’t know which type of service you have, check with the phone company.

CAUTION: Only use the ATLINKS USA 5-2644 power supply that was packed with this unit. Using other power supplies may damage the unit.

8