Arm (HOME) – No delay, instant alarm.
This setting is used when you wish to secure the area but will be home and moving around within the armed area. In the Arm/HOME setting, any Motion Sensors in Zone 1, 2, and 3 will not operate. All Sensors must be closed/not activated in order to set the alarm.
To set the system in HOME mode
HOME Mode
To set the Alarm in Home Mode
Step 1
Enter four digit Security Code
until system is disarmed. In the Arm/AWAY setting, all Sensors in Zones 1, 2, and 3 will trigger the Alarm System. All Sensors must be closed/not activated in order to set alarm.
To set system in AWAY mode
Step 1 - Enter your four digit Security Code.
Step 2 - Press the Arm button two times. The red alarm LED indicator will flash continuously.
AWAY Mode
| Input DC 12V | |
| - | + |
|
| Mute |
|
| Learn |
1 | 2 3 4 Arm | Alert |
|
| Chime |
1 2 3 4 | Armed Power | Off |
| ||
Zone
Only Zones 1, 2, and 3
Step 2
Press and HOLD “Arm ” button for two seconds
Note: Motion Sensors do not operate in HOME Mode.
The Armed LED indicator turns on
Step 3
To disarm, enter the four digit Security Code
| Input DC 12V | |
| - | + |
|
| Mute |
|
| Learn |
1 | 2 3 4 Arm | Alert |
|
| Chime |
1 2 3 4 | Armed Power | Off |
| ||
Zone
To set the Alarm in Away Mode
Step 1
Enter four digit Security Code
Step 2
Press “Arm ” button twice
The Armed LED indicator begins flashing
(45 seconds to exit)
Step 3
To disarm, enter the four digit Security Code
30 seconds to enter)
Step 1 - Enter your four digit Security Code.
Only Zones 1, 2, and 3
Step 2 - Press/hold the Arm button
for two seconds. The red Arm LED indicator will turn on. The system is now Armed.
Arm (AWAY) – Delayed alarm for entry/exit.
After the system is armed a 45 second delay begins. This is to allow time to leave the protected area before system is active. The Control Center will begin beeping and the Armed LED indicator will begin to flash. During the last 10 seconds the beeping will speed up indicating the alarm will arm shortly. Once the alarm has become active, the red LED indicator will continue to flash
12
Note: If a Sensor is triggered in Zone 4 it will not activate the alarm. It will sound an alert tone only. (See Zone 4 page 9)’.
Disarming the System
When you return to the protected area the unit will trigger and give you 30 seconds to disarm the system. To disarm the system at any time, enter the four digit Security Code. Entering the four digit Security Code will disarm the system during the 30 second delay entry period, or even if the alarm has been triggered and the siren is sounding.
