GE 45129 user manual Quick Reference Card, Lets get started, Creating a Personal Security Code

Bypass – You can bypass a Zone so that any Sensors in that Zone (1, 2, and/or 3) will not trigger the alarm regardless of HOME or AWAY setting.

Quick Reference Card

The Control Center comes with a quick reference card and clear storage envelope. Attach the clear envelope using the peel off adhesive and press it to the bottom of the Control Center. Use a pencil to indicate where Sensors are located around your home. On the reverse side of the card are brief instructions for Arming/ Disarming the system and assigning a Sensor to a Zone.

Lets get started...

Use the following tips to select an ideal location Position it…

-in a central location of the home, within a few feet of an electrical outlet.

-some place accessible and easily noticed.

-Away from doors and windows where it could be easily noticed by intruders.

-Away from heat sources such as an oven, stove or vents.

-Away from large metal objects (such as refrigerators, microwaves, etc.) which could effect the

wireless performance.

After you have selected a location for the Control Center, you are ready to set up your system.

1)Plug in the AC adapter to a nearby electrical outlet and plug the other end into the “Input DC12V” jack on the side of the unit. All the LED indicators on the

front of the unit will light up briefly and go out. This indicates the Control Center has completed a brief system check. Only the green power LED indicator should remain on.

2)Place the Control Center in the selected location and rotate the antenna to the upright position for best reception. The Control Center should be able to receive signals from Sensors and Accessories up to 150 feet away.

Creating a Personal Security Code

The Security Code is used to arm and disarm the alarm system. The Control Center comes with a factory default Security Code setting of “1 2 3 4”.

It is recommended to establish your own Personal Security Code. To change the Security Code, locate the Learn button on the side and Arm button on top.

Step 2

Enter the current code

Step 3

Enter new code

Step 4

Re- Enter new

Input DC 12V

Step 1

code to confirm

-

+

Mute

Press and hold

Learn

the Learn button,

Then press and

1

2

3

4

Arm

hold the Arm

Alert

button together

1

2

3

4

Chime

for three seconds

Armed

Power

Off

Zone

Note:

-When setting the Security Code you have 15 seconds to begin making the change. After 15 seconds the unit will time out and return to stand-by mode. If this happens you will need to start over.