Notification switch settings:
Off – In this mode when a Sensor is activated, the Control Center will issue a visual Alert only (flashing Zone LED indicator), no audio will be heard.
The LED indicator will continue to flash as long as the Sensor is activated (door or window is open, garage door is up, etc.)
Chime – In this mode when a Sensor is activated, the Control Center will issue a
Note: A Motion Sensor in Zones 1, 2 or 3 will not respond in the Chime mode. It only functions as an Alarm Sensor.
Alert – (Beeping sound) In this mode when a Sensor is activated, the Control Center will issue a continuous Alert (beeping sound) and a visual Alert (flashing Zone LED indicator). Both the flashing LED indicator and the beep sound will continue until Sensor is deactivated (door or window is closed, etc.). The number of beeps will be determined by which Zone has an activated Sensor.
Zone 1 - you will hear “1 beep…1 beep…1 beep, etc”. Zone 2 - you will hear “2 beeps…2 beeps…2 beeps, etc”. If a Sensor in more than one Zone is triggered, (i.e. Zone 1 and Zone 2 then you will hear “1 beep…2 beeps…, 1 beep… 2 beeps, etc.” )
Note: A Motion Sensor in Zones 1, 2 and 3 will not respond in the Alert mode. It only functions as an Alarm Sensor. A Motion
Sensor can be used for an Alert in Zone 4 only.
Mute – Use this button, while in Alert mode, to temporarily stop the continuous beeping Alert (e.g.
a window open or leaving the garage door up). To activate mute for a certain Zone, press the Mute button after the beeping starts. All triggered Sensors in the Zone will be muted and the LED indicator will continue to flash until the Sensor has been reset. To deactivate the mute, reset the Sensor (close door or window, lower garage door, remove water, etc) for that Zone. If more than one Zone has a triggered Sensor, pressing the Mute button will mute all triggered Zones.
Mode 2 - Dedicated Alert Mode - Zone 4 is a dedicated Zone for alerts only; it is designed for continuous monitoring. It works independently of the Notification Mode switch and the Alarm System. Sensors in Zone
4 will not trigger an alarm (HOME or AWAY). Sensors in Zone 4 do not respond to the Off/Chime/Alert Notification Mode switch.
Mode 3 - Armed/Alarm Mode (Zones 1,2,3)
Arm HOME (Instant alarm) – In this setting the alarm is instant (no delay) when a Sensor is triggered. All Sensors (except Motion Sensors) in Zones 1, 2, and 3 will trigger the alarm. Sensors in Zone 4 will not trigger the alarm. Zone 4 is for Alerts only.
Arm AWAY (Delayed alarm) – In this setting there is a 45 second exit delay before system is armed. This allows time to leave the protected area. There is also a 30 second entry delay; this allows time to enter the protected area and disarm the system before alarm sounds. All Sensors in Zones 1, 2, and 3 will trigger the alarm. Sensors in Zone 4 will not trigger the alarm. Zone 4 is for Alerts only.
Disarm – Entering the 4 digit Security Code anytime the system is armed, will immediately disarm the system, regardless of HOME or AWAY setting.
