Test the Silent Alert
Step 1 - After the Silent Alert has been successfully linked with the Control Center, press and hold the Mute button on the Control Center for three seconds. This action sends a test signal.
Step 2 - When the Silent Alert receives the test signal from the Control Center, one LED indicator on the Silent Alert will begin to flash once a second. It will continue to flash for 30 seconds.
Alarm Siren
The Alarm Siren will increase your system’s sound. Use in areas where Control Center Siren cannot be heard.
Adding a Alarm Siren
Step 1 - Remove cover | Low Batt On Armed | |||||
|
|
|
|
|
| |
on top of the Alarm |
|
|
|
|
|
|
Siren. Plug in the AC |
|
|
|
|
|
|
adapter. Insert the |
|
|
|
|
|
|
antenna and slide |
|
|
|
|
|
|
mode switch to the |
|
|
|
|
|
|
‘ON’ position. |
|
|
|
|
|
|
Step 2 - Press and hold |
| ON/OFF | LEARN | |||
|
|
|
|
|
| |
the Learn button inside |
|
|
|
|
|
|
|
|
|
|
|
|
the Alarm Siren. The ‘ON’ indicator on the front will begin to flash and it will sound three beeps.
Step 3 - While continuing to press the Learn button, press and hold the Mute button on the side of the Control Center for three seconds. The Control Center will send a test signal to the Alarm Siren.
When the Alarm Siren receives the test signal it will sound a long tone and the ‘ON’ indicator will stop
flashing. This indicates the Alarm Siren has been linked with the Control Center. Replace cover to Alarm Siren.
Test the Alarm Siren
Step 1 - After the Alarm Siren has been successfully linked with the Control Center press and hold the Mute button on the Control Center for three seconds.
Step 2 - When the Alarm Siren receives the test signal from the Control Center, one LED indicator on the Alarm Siren will begin to flash. It will continue to flash for 30 seconds. This indicates it has received the test signal.
The Signal Repeater will | Signal | ||
extend the range of the | Repeater | ||
|
|
| |
Choice Alert system up to |
|
|
|
150 feet from its location |
|
|
|
– Effectively repeating the |
| ||
|
|
| |
Test | |||
signal from any Sensor |
|
|
|
back to the Control Center should a Sensor be located
out of range. The Signal Repeater does not send or receive signals to the Silent Alert or Alarm Siren.
Adding a Signal Repeater
Step 1 - Find an electric outlet near the Sensor having trouble communicating with the Control Center. Make certain the location is between the Sensor and Control Center. Plug the Signal Repeater into the outlet and press the ‘Test’ button on the side of Signal Repeater. It will send a test signal out to the Control Center and the LED indicator on the Signal Repeater will flash rapidly for about one
14second, then go out.