Installation Instructions
2REVERSE DOOR SWING
SKIP THIS STEP IF DOOR SWING SUITS THE INSTALLATION
Parts Included:
•Top left case hinge
•Bottom left case hinge
•Left and right side decorative hinge cover
•Decorative hinge screw hole cover
•Torx® driver bit
Tools Required:
•Phillips screwdriver
•Electric drill
To remove the door:
•Flatten the shipping carton to use as a pad.
•Remove the 2 screws and the toekick. Set aside the screws and toekick for final installation.
•Use the supplied Torx® bit and electric drill to remove
the 3 screws holding the top case hinge. Lift off the hinge. (Screws will be used to install the new hinge.)
•Lift the door off the bottom case hinge.
•Remove the bottom case hinge pin and bracket.
To reinstall the door:
1.Remove the door stop and cam riser on the bottom right side of the door.
2.Remove the bottom fill plug on the bottom left side of the door.
3.Reinstall the original door stop and cam riser onto the bottom left side of the door.
4.Reinstall the bottom fill plug on the bottom right side of the door.
5.Remove the top fill plug on the top left side of the door.
6.Reinstall the top fill plug on the top right side.
7.Install the new supplied bottom case hinge pin and bracket onto bottom left side. Ensure plastic cam riser is on the case hinge pin.
8.Place the door onto the bottom case hinge.
9.Install the supplied
10.Select the hinge cover marked with an “L”.
11.Peel backing off the tape inside the decorative hinge cover.
12. Press and snap the hinge cover into place.
13. Snap the screw hole cover into place on the opposite side.
IMPORTANT: Check to be sure screws are tight and that the door is straight
and does not sag. The door should swing freely.
Install
3 Hinge
Screws
Remove
Top Hinge
Hinge
Pin and
Bracket
Door Stop
and Cam Riser
Remove
Hinge
Install Toekick
The toekick has a cutout on the left and right sides.
1. Remove the |
|
|
plug on the |
| Move Fill |
left side and |
| |
| Plug to | |
reinstall on | Spacer | Right Side |
the right side. |
| |
Standoff |
| |
|
|
2. Install original
screws and spacers.
Install screws through the spacer standoff, toekick and into the base as shown.
11