Installation Instructions
Wine Chiller and Beverage Center
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.• IMPORTANT – Save these instructions |
for local inspector’s use. |
• IMPORTANT – Observe all governing |
codes and ordinances. |
• Note to Installer – Be sure to leave these |
PRODUCT CLEARANCES
The wine chiller and beverage center is factory set for a 110° door swing.
When installed in a corner:•Allow 4″ min. clearance on the hinge side for the 90° door swing and to allow racks to slide out.
•Allow 10″ minimum clearance on the hinge side for a full 110° door swing.
instructions with the Consumer. |
• Note to Consumer – Keep these instructions |
for future reference. |
• WARNING – This appliance must be |
properly grounded. See “Electrical Supply.” |
• If you received a damaged wine chiller or beverage |
center, you should immediately contact your dealer |
or builder. |
• Skill Level – Installation requires basic mechanical |
skills. Proper installation is the responsibility of the |
installer. Product failure due to improper installation |
is not covered under the GE Appliance Warranty. |
10" Minimum
to Wall
110°
90° Door Swing
90°
4" Minimum
to Wall
WARNINGS:
•Use this appliance only for its intended purpose.
•Immediately repair or replace electrical service cords that become frayed or damaged.
•Unplug the unit before cleaning or making repairs.
•Repairs should be made by a qualified service technician.
•The door swing is reversible on all models. If desired, change the door swing before installation.
Choose the location:•These products may be closed in on the top and three sides as long as the front is unobstructed for air circulation and proper access to the door.
•Do not install these products where the temperature will go below 55°F (13°C) or above 90°F (32°C).
•Do not install where it will be subject to direct sunlight, heat or moisture.
•These products are not designed to be stacked one over the other.
8
