UNAVAILABLE | Indicates the handset is out of range. Or an additional handset |
| is in use. Or there has been a base power failure, in which case |
| you must place all handsets on the main base cradle for 20 |
| seconds to |
UNKNOWN NAME/ | The incoming call is from an area not serviced by Caller ID or |
CALLER/NUMBER | the information was not sent. |
WAITING HANDSET | Prompt telling you to enter registration mode of handset. |
REGISTRATION
Handset Sound Signals
Signal | Meaning |
A long warbling tone (with ringer on) | Signals an incoming call |
Three short beeps | Page signal |
One short beep (every 7 seconds) | Low battery warning |
Troubleshooting Guide
Telephone Solutions
No dial tone
•Check and repeat installation steps:
Ensure the base power cord is connected to a working outlet .
Ensure the telephone line cord is connected to the base and the wall jack.
•Connect another phone to the same jack; if there is still no dial tone, the problem might be your wiring or local service.
•The cordless handset may be out of range of the base. Move closer to the base.
•Ensure the battery is properly charged (16 hours).
•Ensure the battery pack installed correctly.
•Did the handset beep when you pressed the TALK/CALL BACK or SPEAKER button? The battery may need to be charged.
•Place handset in charge cradle for at least 20 seconds.
Dial tone is OK, but can’t dial out
•Make sure the TONE/PULSE setting on the base is set to the type of phone service you are subscribed to.
41
