29
5. Press the memory button or mem button again to save your selection. The display
shows ENTER TEL NUMBER.
NOTE: If you make a mistake, press the delete button on the base
or chan/delete on the handset to backspace and erase the wrong
character(s) or number(s).
6. Use the touch-tone pad to enter the area code followed by the telephone number
(up to 24 digits, including pauses) and press the memory button or mem button again
to save your selection. You will hear a confirmation tone.
7. To enter another name and number in a different memory location, return to step 1
and repeat the process.
Storing a Redial Number
1. Make sure the phone is OFF (not in TALK mode).
2. Repeat step 1 through 6 in Storing a Name and Number in Memory.
3. Press redial to display the redial number and name.
4. Press memory or mem button again to confirm.
NOTE : If the number you want to redial has more than 24 digits,
the telephone number cannot be stored in memory.
Inserting a Pause in the Dialing Sequence
Press the #pause button on the touch-tone pad to insert a delay in the dialing
sequence of a stored telephone number when a pause is needed to wait for a dial tone
(for example, after you dial 9 for an outside line, or wait for a computer access tone.)
Each pause counts as 1 digit in the dialing sequence.
Reviewing, Changing or Deleting Stored Names/Numbers
To Review: Press mem button on the handset or memory button on base, then press
the caller id (9 or :) button (on base) or the CALLER ID-VOLUME (6 or 5) button (on
cordless handset) to scroll through the stored numbers. Or press the memory location
number.
To Change: Follow the steps under Storing a Name and Number in Memory except
replace the stored name or number with the new information.