GEAppliances.com
When the air conditioner is turned on, it will automatically start in the setting last used.
Safety
COOL Mode
Use the COOL mode with HIGH (3), MED (2) or LOW (1) fan for cooling. Use the INCREASE ▲ / DECREASE ▼ pads to set the desired temperature between 64°F and 86°F in 1°F increments.
A thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while set to COOL, it will take approximately 3 minutes for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal
For Maximum
For Quieter & Nighttime
NOTE: If you switch from a COOL setting to OFF or to a fan setting, wait at least 3 minutes before switching back to a COOL setting.
Instructions Operating Instructions
FAN Mode
Use the FAN at HIGH (3), MED (2) or LOW (1) to provide air circulation and filtering without cooling. Since fan only settings do not provide cooling, a temperature setting will not be displayed.
Vent Control (on some models)
The vent control is located on the inside of the air louvers in the lower right corner.
When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside.
To open the vent, push the lever to the right.
To close it, push it to the left.
Air Direction—Up and Down (on some models)
Fingertip pressure on the horizontal louvers adjusts the air direction up or down.
OR
Air |
|
On some models, the |
|
adjusted by the louver levers or by grasping and |
|
moving the inner vertical louvers. | OR |
5
Installation Instructions Troubleshooting Tips Consumer Support
