GE ASH12, ASH10 installation instructions Power Outage Recovery Feature, Remote Control

Operating Instructions Safety Instructions

About the controls on the air conditioner—models with touch pads.

Features and appearance will vary.

Cool on Fan on

Timer on

Air Conditioner Controls Remote Control

Tips Installation Instructions

ON/OFF

Turns air conditioner on and off.

Display

Shows the set temperature, time remaining on timer or fan speed (1–LOW, 2–MEDor 3–HIGH).

MODE

Use to set the air conditioner to COOL or FAN mode.

Increase ▲ /Decrease ▼ Pads

Use to set temperature when in COOL mode.

FAN

Use to set the fan speed to LOW (1), MED (2) or HIGH (3).

TIMER

ON—When the air conditioner is off, it can be set to automatically turn on in 1 to 12 hours at its previous setting. Each touch will set the time in hours.

OFF—When the air conditioner is on, it can be set to automatically turn off in 1 to 12 hours. Each touch will set the time in hours.

To cancel the timer, press the TIMER pad until the display time disappears.

Remote Control Signal Receiver

Consumer Support Troubleshooting

Power Outage Recovery Feature

In the case of a power outage or interruption, the	will reset to the original setting. You may need to set
unit will automatically re-start in the settings last	a new time if desired.
used after the power is restored. The TIMER feature

Remote Control

■ To ensure proper operation, aim the	■ Make sure nothing is between the air
remote control at the signal receiver	conditioner and the remote control that
on the air conditioner.	could block the signal.
■ The remote control signal has a range of	■ Make sure batteries are fresh and installed
up to 21 feet.	correctly—see the Care and Cleaning section.

4