Installation Instructions
6MEASURE, CUT AND INSTALL FILLER PANELS
AMeasure from the edge of the panel marks (see Prepare the Window) to the inside of the window track on each side. (A and B)
Sill
|
| Window track |
|
| 133⁄8″ | 133⁄8″ |
|
A | Width of the air | B | |
Left side | conditioner | Right side | |
(panel marks) |
Gasket
Angle
Gasket Panel
Tab
Angle
Type C (painted screws)
BMark the A and B measurements on each side of the filler panel board. Cut the panels and discard the center piece. Note position of the notches.
B |
| A |
Right |
| Left |
side |
| side |
are(holeson the left) | piece | (holes are ontheright) |
| Filler |
|
| Panels |
|
| Cut |
|
| panels |
|
| and |
|
| discard |
|
| center |
|
CPut together the panel assemblies. Remove the paper backing from the case side gasket and attach it to the angle. Push a pencil point through the gaskets to locate the holes in the angles.
DInstall the panels in the window. Place the spring clips 3″ from the top and the bottom. Squeeze and push the clips to fit in the window track and the tab into the sill support.
3″
Hook the tab into the sill support
19