GE GSD2600D manual Possible Cause And Remedy, The Problem Solver continued

~...To Save Time and Money— Jefore you call for service, check the Problem Solver

If you have a problem, it may be minor. You may be able to correct it yourself. Just use this Problem Solver to locate your problem and then follow the suggested recommendations.

The Problem Solver

PROBLEM

CONTROL PANEL LIGHTS GO OFF WHEN YOU’RE SETTING CONTROLS

DISHWASHER WON’T RUN

UNUSUAL NOISE

POSSIBLE CAUSE AND REMEDY

Time too long between touching of selected pads. Each pad must be touched within 30 seconds of the others. To relight, touch any pad again. Or unlock and relatch door.

A fuse in your home may be blown, or the circuit breaker tripped. Replace fuse or reset circuit breaker. Remove any other appliances from the circuit.

Utensils may not be secure on rack pins. Or something small may have dropped from the rack. Water is causing utensils to rattle. Make sure everything is securely placed in dishwasher.

Water draining out of tub immediately after you touch CLEAR RESET pad. The sounds you hear are normal ones.

DISHES DON’T DRY	Make	sure	water temperature			is correct.		(See page 10.)
	Unload the bottom rack first. Water from dishes in the top rack may
	be spilling into the bottom rack.
	Check for improper loading. Dishes shouldn’t nest together. Avoid
	overloading.
	Check the rinse agent dispenser to see that it’s not empty.
UNCLEAN DISHES	Check	water temperature.			It should		be at	least 120”E (To test,		see
AND FLATWARE	page	10.)
	Water pressure may be temporarily low. Turn on a faucet. Is water
	coming out slower than usual? If so, wait until pressure is normal
	before	using your		dishwasher.
	Plugged air gap. (See page 16.)
	Improper rack loading. (See pages 12-14.)
I BLACK OR GRAY	Aluminum		deposits	often	leave marks when				they rub against	other
MARKS ON DISHES	things.	Remove marks with				a mild	abrasive		cleanser.

The Problem Solver (continued)