The SYSTEMS MONITOR tells you if something’s wrong
| Appears when power to dishwasher is interrupted. See if dishes are |
| dirty or if water is standing in tub. To pump water out of tub, push |
| START then CLEAR/RESET or overfill can occur. Replace detergent, if |
| missing. Reset controls and repeat cycle, if necessary. If there has |
| been a POWER FAILURE, your last settings will be erased and your |
| dishwasher will automatically program NORMAL WASH and |
| HEATED DRYING. |
, CUP OPEN | Appears after START pad is touched if detergent cup is not closed |
| properly. Unlatch doo~ add detergent to cup if it has been spilled, |
| close cup and relatch door. If cup is latched properly and CUP OPEN |
| display still appears, you may start wash cycle by pressing START |
| pad a second time. CALL FOR SERVICE, but dishwasher may |
| continue in use. |
BLOCKED DRAIN | When BLOCKED DRAIN appears after cycle is completed, dishwasher |
| has a partial restriction and is taking too long to drain. Clean the air |
| gap. (See page 16.) If BLOCKED DRAIN still appears, try another |
| cycle. If situation is not corrected CALL FOR SERVICE. |
BLOCKED DRAIN and C2 | When BLOCKED DRAIN appears and dishwasher is stopped and will |
| not drain; drain line is completely clogged. Clean the air gap. To get |
| dishwasher to pump out, start any cycle and then push CLEAR/ |
| RESET If air gap is not at fault, CALL FOR SERVICE. |
SEE DOOR LABEL | Appears in the SYSTEMS MONITOR with any of the above word |
| signals or any of the following fault codes. Door label gives brief |
| summary of instructions shown here. |
(“’
“w
r,
+-