C2 | Appears in combination with BLOCKED DRAIN and indicates drain- |
| Iine is completely clogged. See page 6, BLOCKED DRAIN and C2. |
C3 | Appears when the dishwasher will not go into a |
| Dishwasher will not operate. CALL FOR SERVICE. |
C4 | Appears when there is too much water in the dishwasher. Turn off |
| water line to dishwasher before unlatching doo~ CALL FOR SERVICE. |
| Unless water is in tub after P~ then push START and CLEAR/RESET. |
| If there is no water in the dishwasher at the time of a drain out period, |
| the cycle stops and C5 is displayed. Check that water line to |
| dishwasher is not turned off. If water line is not at fault CALL FOR |
| SERVICE. |
C6 | Amears if water does not reach desired temperature for good |
| washability within the |
| heater may be out; or dishwasher may have been used too soon after |
| laundry or family baths. |
| Water heater thermostat may be set too low. Check water temperature |
| according to instructions on page 10. Reset water heater and try |
| another dishwashing cycle. If water temperature is correctly set at |
| water heater and C6 appears consistently CALL FOR SERVICE. There |
| may be a fault in the dishwasher’s heater. |
C7 | Indicates that temperature sensing device is defective. Dishwasher |
| will not heat water. CALL FOR SERVICE. |
NOTE: If control panel doesn’t respond to inputs, shut off power from dishwasher at fuse or circuit breaker. Wait 5 seconds and restore power. Try inputs again.