Installation InstructionsICEMAKER INSTALLATION INSTRUCTIONS

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

• CAUTION – Unplug the Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet.

2REMOVE THE OUTLET COVER•Remove the outlet cover

with a flat-blade screwdriver.

SideBack

TOOLS YOU WILL NEED

Flat blade and Phillips

Pliers

screwdrivers

 

PARTS INCLUDED

1

 

 

 

2

3

NO.

DESCRIPTION

QUANTITY

1

Water Fill Tube

1

2

Ice Fill Guide

1

3

Water Fill Tube Seal

1

1INSTALL FILL TUBE

• If the refrigerator already has a water tube inlet on the back of the refrigerator, go to Step 2.

• Remove and discard the white plug

 

Remove

from the lower left back corner of

 

 

plug

the freezer wall.

 

 

 

 

•Go to the back of the refrigerator. Find the small label in the upper right hand corner and peel it off. Then discard the label.

• Peel one side of the paper away

Seal

from the water fill tube seal, slide

 

the seal along the tube and affix

 

to the back side of the water

 

tube inlet flange.

 

• Remove the adhesive backing on the opposite side

of the water fill tube seal and slide the tube into the hole

near the top at the back of the refrigerator. Firmly press on the inlet to secure it to the refrigerator.

3 PREPARE FOR INSTALLATION

Inside the freezer, loosen the two mounting screws, but do not screw them all the way out. If your model does not have the screws already in the freezer wall, look for two plug buttons. Remove the plug buttons and insert the two Phillips head screws. The screws should extend approximately 1/2″ (13mm) out from the freezer wall.

Mounting screws

4SET POWER SWITCH TO O (off)

Set the icemaker power switch to O (off). Leave the power switch in the O (off) position until the refrigerator is connected to the water supply to prevent premature operation.

Hole for

wire tie

Power

Switch

(Appearance may vary)

13