Installation Instructions

8REHANG THE REFRIGERATOR

DOOR

Lower the refrigerator door onto the bottom hinge pin.

Plastic

Washer

Screw the two screws into the center hinge location on the left side with a 5/16″ socket and ratchet.

Straighten the door and place the center hinge pin into the opening on top of the door. Remember to include the washer.

Move the door into place, so you can align the center hinge bracket over the center hinge holes on the left side. Insert and tighten the two screws with a 5/16″ socket and ratchet.

NOTE: Ensure the washer is in place on top of the hinge pin.

Plastic Washer

Hinge Pin

Center Hinge

Bracket

Refrigerator Door

9REHANG THE FREEZER DOOR

Lower the freezer door onto the center hinge pin.

Be sure the washer is in place.

Center Hinge Pin

Plastic

Washer

Lift the top hinge so the pin fits into the door socket.

Support the door on the handle side and make sure the door is straight and the gap between the doors is even across the front. While holding the door in place, tighten the top hinge screws.

10ADJUST THE DOORS(IF NEEDED)If the freezer door is too high:

Remove the hinge

 

 

 

cover on top of the

Loosen screws.

5/16″

freezer door and

 

 

 

 

loosen the four

 

 

 

screws with a 5/16″

 

 

socket and ratchet.

 

 

 

Replace the hinge

 

 

 

cover.

 

 

 

If both doors are too high:

 

 

1. Remove

 

 

 

the hinge

Loosen screws. 5/16″

 

cover on

 

 

 

 

top of the

 

 

 

freezer

 

 

 

door and

 

 

5/16″

loosen the

 

 

 

 

 

four screws

 

 

Loosen

with a

 

 

5/16″

 

 

screws and

socket and

 

 

slide left to

 

 

lower doors.

ratchet.

2.Loosen the two center hinge screws with a 5/16″ socket and ratchet.

3.Slide the center hinge to the left to lower the doors.

4.Fully tighten all screws and replace top hinge cover.

If both doors are too low:

1. Remove the

 

 

hinge cover

Loosen screws.

5/16″

on top of

 

 

the freezer

 

 

door and

 

 

loosen the

 

5/16″

four screws

 

 

 

with a 5/16″

 

 

socket and

 

Loosen

ratchet.

 

screws and

 

 

slide right to

2. Loosen the

raise doors.

two center

 

hinge screws

 

with a 5/16″ socket and ratchet.

 

3.Slide the center hinge to the right to raise the doors.

4.Fully tighten all screws and replace top hinge cover.

NOTE: Save the door spacer.

 

Doors may settle with use.

Door Spacer

25