Installation Instructions

ICEMAKER INSTALLATION INSTRUCTIONS (CONT.)
5INSTALL THE ICEMAKER FILL CUP

Install the icemaker fill cup (side-mounted) into the icemaker as shown.

Icemaker fill cup

6PLUG IN THE ICEMAKER

Holding the icemaker in place, insert the icemaker power cord plug into the socket on the back wall, making sure the prongs and holes are matched. Press the plug firmly into the socket. Lock the plug in place by clipping the restraints onto each side of the plug. Make sure the restraints click into place.

7MOUNT THE ICEMAKER

•Lift the icemaker so the fill tube extension fits in the fill cup opening. Hang the icemaker on the two screws.

Make sure:•The power cord is still firmly in the socket.

•The fill tube extension extends into the

fill cup opening at the back of the icemaker. (Check the rear of the refrigerator to make sure the fill tube has not been pushed out of the back of the refrigerator).

•The icemaker mounting screws are located in the uppermost position of the mounting slots.

THEN SECURELY TIGHTEN THE ICEMAKER MOUNTING SCREWS.

Fill tube extension

Fill cup opening

8INSTALL THE ICE BUCKET

Place the ice bucket under the icemaker.

Make sure the icemaker power switch is in the O (off) position.

Ice bucket

9 REMOVE THE COVER

Use a Phillips head screwdriver to remove the compressor compartment access cover. This requires removing six screws which attach the cover to the back of the refrigerator case.

Be sure to save the screws as the access cover must be reinstalled later to ensure your refrigerator will function properly.

14