GE GX1S04C, GX1S15C, GN1S04C Step-by-stepinstallation instructions, Faucet Installation, needed

Step-by-step installation instructions.

Faucet Installation

Be sure there is room underneath the sink to make the needed connections. Select one of the following places to install the faucet:

—IN an existing sink spray attachment or soap dispenser hole.

—IN a hole to be drilled in the sink top.

—IN a hole to be drilled in the countertop, next to the sink.

NOTE: Looking at second illustration at right, be sure the faucet base will fit flat against the surface at the selected location so the gasket will seal.

	If drilling is needed, make a 3⁄4″ dia. hole. Be sure to use the proper
1
	procedure for drilling porcelain or stainless steel. Special drill bits may be
	needed.
	Place small gasket, base and large gasket (in that order) onto the faucet
2
	stem. Next, place lock washer and hex nut onto faucet stud.
	Insert washer into tubing adapter. Securely tighten to faucet stud.
3
	Feed the length of 3⁄8″ OD tube from the bottom, up through the
4
	mounting hole. Connect to the tubing adapter as shown in second
	illustration, tightening the compression nut securely.
	Remove the short shipping tube and insert the spout into the
5
	faucet body. Rotate spout into place.
	Lower the faucet assembly into place on the underside of the mounting
6
	hole. Place the mounting bracket above the lock washer. While holding

the mounting bracket in place, securely tighten the hex nut.

Spout

Lever

Faucet

Faucet stud

ASSEMBLED

Small gasket

Base

Large gasket

Sink

Mounting bracket

Lock washer

Hex nut

Plastic washer

Tubing adapter

Compression nut

Compression nut

3/8″ tubing, (run to Filter outlet)

6