Step-by-step installation instructions.
Faucet Installation for Models GXST03C and GXSL03C (rev. 2)
Be sure there is room underneath the sink to make the needed connections. Select one of the following places to install the faucet:
NOTE: Looking at second illustration at right, be sure the faucet base will fit flat against the surface at the selected location so the gasket will seal.
1 | If drilling is needed, make a 3⁄4 ″ dia. hole. Be sure to use the proper |
procedure for drilling porcelain or stainless steel. Special drill bits may |
be needed.
Spout
Lever
Faucet
Faucet
studASSEMBLED
Small gasket
2
3
4
5
6
Place small gasket, base and large gasket (in that order) onto the faucet stem. Next, place lock washer and hex nut onto faucet stud.
Insert washer into tubing adapter. Securely tighten to faucet stud.
Feed the length of 3⁄8 ″ OD tube from the bottom up through
the mounting hole. Connect to the tubing adapter as shown in second illustration, tightening the compression nut securely.
Remove the short shipping tube and insert the spout into the faucet body. Rotate spout into place.
Lower the faucet assembly into place on the underside of the mounting hole. Place the mounting bracket above the lock washer. While holding the mounting bracket in place, securely tighten the hex nut.
Base
Large gasket
Sink
Mounting bracket
Lock washer
Hex nut
Tubing
insert
Tubing adapter
Compression nut
Tubing insert
Compression nut
3/8″ tubing, (run to Filter II outlet)
Tubing adapter
7