www.GEAppliances.com
10
11
12
13
14
Turn on the filtered water faucet. Then, slowly open the water supply/saddle valve and allow the filter housing to fill.
Close the filtered water faucet. Then, check for leaks between the sump and the head.
NOTE: If leaking, turn off the water supply and turn on the filtered water faucet. Disassemble the filter housing and check the
If you are replacing the batteries, remove, properly discard and install two new AA alkaline batteries in the battery pack. Removing the batteries or momentarily disconnecting the lead wires resets the
The filter cartridges contain activated carbon. When new, turn on the filtered water faucet for ten minutes to flush the system.
Place filter change label on sump, inside cabinet door, or in another convenient location. Write in date of filter change for future reference. Filters should be changed every six months.
Flush Procedure
Whenever water of unknown quality is passed through the GE Water Filtration system, filter elements should be discarded and the filtration system flushed.
Circumstances that may require flushing the system are:
■
■Flooding of the GE Water Filtration system.
■
The procedure for flushing the GE Water Filtration system is:
1
2
3
4
See Filter Cartridge Replacement section and follow steps 1, 2, 3 and 4.
Next, reinstall the sumps (without the filter elements), turn water on and flush water through the faucet for one minute.
Then, turn water off, remove sumps, empty water out of sumps and install new filter elements.
Follow steps
11