![](/images/new-backgrounds/1090153/9015351x1.webp)
STEP 2
PREPARE FOR ELECTRICAL CONNECTION
Use only a
These cord sets are provided with ring type terminals.
The electrical rating of the cord must be 125/250 volts minimum, 40 amperes.
NOTE: Only a
STEP 3
1.Locate connector block at the bottom rear of range and remove rear wiring cover.
2.Directly below the connector block is a hole with a knockout ring for accommodating conduit fittings. Brackets provided are used to support the flexible cord strain relief, which must be securely attached to the cord set.
STEP 4 | I |
|
HIRE SYSTEM | 4 | + |
. |
Power Cord
SCREW | + | POWER CORD |
|
| RING TERMINAL |
| 6 |
|
| & | +- POWER |
&k | CORD |
:X#l~CTOR /
h4::ABLE
TERMINAL49-
I
Cable I)irect
WIRING COVER J (SHOWN REMOVED)
STRAIN RELIEF
:~+l#~CTOR
.
BRACKETS\ (PROVIDED WITH
RANGE *CORD. SET. !
NOT
dfs$!i?
/“*\
a? 2 \vl/
“:
1. Copper Wiring
Connect the neutral or grounded wire of the supply circuit to the neutral terminal of the connector block, located in the center. The power leads must be connected to the outside (brass colored) terminals.
GROUNDING STRAP (GROUNDED TO RANGE)
26