![](/images/new-backgrounds/1090153/9015341x1.webp)
4?,,~ Tilt-Lock (stand-up) Units
You can lift a
To reposition the tilt-lock unit:
● Replace the drip pan then the |
trim ring into the recess in |
the cooktop. |
● Put the trim ring in place over the |
,:) |
... . |
$2drip pan. The drip pan must be |
under the trim ring. |
● Guide the surface unit into place |
Do not lift a
plug it back in. “
Repeated lifting of the
To replace a
●Replace the drip pan into the recess in the cooktop. Make sure opening in pan lines up with receptacle. If you have separate trim ring, put it in place over the drip pan. The drip pan must be under the trim ring.
Separate Drip Pan & Trim Ring installation/Removal~
Re
Adjusting Oven Thermostat
Use time given on recipe when cooking the first time. Oven thermostats, in time, may “drift” from the factory setting and differences in timing between an old and a new oven of 5 to 10 minutes are not unusual. If you find that your foods consistently brown too little or too much, you may make a simple adjustment in the thermostat (Oven Temp) knob.
Pull knob off of shaft, look at back of knob and note current setting before making any adjustment.
To increase temperature, turn toward HI; to decrease turn toward LO. Each notch changes temperature 10 degrees.
so it fits evenly into the trim ring. |
Plug-In Units
(On models so equipped)
Plug-in units can be removed.
Lift a
●Insert the terminals of the
c Guide the surface unit into place so it rests evenly.
Note: The drip pan must be under the trim ring.
CAUTION
●Do not attempt to clean
QDo not immerse
●Do not bend the
. Do not attempt to clean, adjust or in any way repair the
1.Pull off knob. Loosen both screws on back of knob.
2.Move pointer one notch in desired direction. Tighten screws.
3.Return knob to range, matching
21