Installation Instructions
A
Cutout for 30″ (76.2 cm) Single Built-In
Ovens only For JCTP30, JCTP70, PCT916, PCT920 models only.
Cutout Width | 24.1 cm | |
72.4 cm | ||
(9 1/2”) | ||
(28 1/2”) Min. | ||
Max. | ||
72.7 cm | ||
| ||
(28 5/8”) Max. |
| |
|
|
Allow 1.75 cm (11/16”)
for overlap of oven over side edges of cutout
Opening | Cutout | ||
between | Height | ||
inside walls | 69.2 cm | ||
must be at | (27 1/4”) Min. | ||
least 72.4 | cm |
| 69.4 cm |
| |||
(28 1/2”) | wide |
| (27 5/16”) Max. |
|
|
|
|
53.3 cm
(21”)
Junction Box Location
55.9cm (22”) to Bottom of Junction Box
Cabinet Width | 76.2 cm (30”) | |
Recommended |
|
|
Cutout Location |
|
|
from Floor | 82.6 cm (32 1/2”) | |
Cutout Depth | 59.7 cm | |
| (23 | 1/2”) Min. |
Cutout Width | 72.4 cm | |
| (28 | 1/2”) Min. |
| 72.7 cm | |
| (28 | 5/8”) Max. |
Cutout Height | 69.2 cm | |
| (27 | 1/4”) Min. |
| 69.4 cm | |
| (27 | 5/16”) Max. |
Allow a minimum of 53.3 cm (21”) for clearance to adjacent corners, drawers, walls, etc. when door is open
Allow 2.5 cm (1”) for overlap of oven top and
3.2cm (11⁄4”) bottom of cutout
Cabinet
Width
76.2 cm (30”)
Recommended cutout location from floor
82.6 cm (32 1/2”)
NOTE: If the cabinet does not have a front frame and the sides are less than 1.9 cm (3/4”) thick, shim both sides equally to establish the cutout width.
If the cabinet does not have a solid bottom, two braces or runners must be installed level with the bottom of the cutout to support the weight of the oven. For single ovens, the runners and braces must support 68 kg (150 lbs.).
Suitable
Bracing to Support Runners
C | 5 cm x 10 cm |
L | (2” x 4”) or |
| equivalent |
| runners level |
| with bottom |
| of cutout |
NOTE: If marks, blemishes or the cutout opening are visible above the installed oven, it may be necessary to add wood shims under the runners and front trim until the marks or opening are covered.
54.9cm (21 5/8”)
Over Centerline
of Cabinet
These ovens are not approved for stackable installation.
5