Installation Instructions
A
Cutout for 30″ (76.2 cm) Single
Ovens only – Over a Warming Drawer
For JCTP30, JCTP70, PCT916, PCT920 models only.
Per Warming
Drawer
Requirement
1” (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
Rear Wall Per Warming
Drawer Requirement
2” (5.1 cm) Min.
NOTE: Install the oven only with specific models listed on the label located on top of the oven.
NOTE: Additional clearances between cutouts | • When installing a Warming Drawer below |
may be required. Check to be sure the oven | a single oven, a separate 120V, 60 Hz, |
supports above the Warming Drawer location | properly grounded receptacle must |
do not obstruct the required interior depth and | be installed. Refer to installation instructions |
height. | packed with the Warming Drawer for specific |
| installation requirements. |
8