GE JE1390 Tips, Before you call for service…, Safety Instructions Operating Instructions

Safety Instructions

Operating Instructions

Tips

Before you call for service…

Troubleshooting Tips

Problem	Possible Causes	What To Do
BAD PROBE appears	The probe has not been	•Insert the probe properly into the receptacle.
on display	completely inserted into
	the receptacle.
	The probe is defective.	•Replace the probe.
LOCKED appears	The control has been locked.	•Press and hold CLEAR/OFF for about 3 seconds
on display		to unlock the control.
HOT—OVEN IS HOT	The temperature inside the	•This is normal.
appears on display	oven is greater than 200°F.
	One of the sensor cooking	•These features will not operate when the oven is hot.
	pads was pressed when the
	temperature inside the oven
	was greater than 200°F.
You hear an unusual,	You have tried to start the	•Start over and enter a valid time of day.
low-tone beep	Reminder without a valid
	time of day.
	You have tried to change	•Many of the oven’s features are preset and cannot be
	the power level when it	changed.
	is not allowed.

Things That Are Normal With Your Microwave Oven

Troubleshooting

Customer Service

■Steam or vapor escaping from around the door.

■Light reflection around door or outer case.

■Dimming oven light and change in the blower sound at power levels other than high.

■Dull thumping sound while oven is operating.

■TV/radio interference might be noticed while using the microwave. Similar to the interference caused by other small appliances, it does not indicate a problem with the microwave. Plug the microwave into a different electrical circuit, move the radio or TV as far away from the microwave as possible, or check the position and signal of the TV/radio antenna.

32