Instructions for Drilling from Bottom
1.If your cabinet has a bottom rail, measure the thickness and cut that amount off the front edge of Template 2 using the template cut lines as a guide. Also, if your cabinet is less than 12”deep, cutoff the amount by which the cabinet depth is less than 12”.
2.Tape the cut edge of Template 2 against the back side of the front rail and position it flat against the bottom side of the cabinet.
(Note: On some cabinets a small bracket or glue block is used between the overhang and the underside of the cabinet bottom. If this is true of your cabinets, cut Template 2 to fit around the bracket or g~ueblock so that it will be flat on the cabinet bottom when attached. Fig. 12)
●Position the remaining piece of Template 2 under the cabinet and align the hole center lines with the arrows on Template 1 so that the distance from the right hole center to the left hole center measures the distance indicated on Template 1. (Youwill have to cut excess paper from the middle of the template to make it lay flat.)
●Tape Template 2 in place after cutting it to fit. (The cut line along the front edge of the template must be placed against the back of the front rail.) (Fig. 14)
Front
Template 2 rail
Fig. 14
Selecting Your
Mounting Bolts
1.Youshould have four sets of bolts of varying lengths in the installation package. Select one bolt of each size.
2.Hold each bolt against the cabinet front rail. Pick the bolt that extendsbeyond the top of the bottom shelf by 3~16°to 13/16!’This will be the bolt length needed for your cabinets. (Fig. 15)
Fig. 15
Fig. 12
Bottom rail Glue block
Drilling the Mounting Holes
We recommend that you wear safety glasses while drilling to prevent possible eye damage from cabinet shavings.
Note: It is important to pick the correct bolt length needed for your cabinets. If the bolt is too short, it won’t reach the oven. If the bolt is too long, it will not permit the oven to be drawn snugly up to the cabinet.
3. From inside the cabinet, insert |
3.If you have a partition you must do the following:
●Cut Template 2 into two pieces to fit on each side of the partition.
●Tape one piece of Template 2 under the cabinet. (The cut line along the front edge of Template
2 must be placed against the back of the front rail.) (Fig. 14)
●Tape Template 1 to the rear of the cabinet and align the arrows with the hole center line on Template 2. (Fig. 13)
1. Use a center punch or nail to make an indentation for centering the drill bit.
2.Drill through Template 2 at the four black drilling holes indicated on the template. (Drill should be held straight to ensure proper alignment of bolts.)
3.Afier drilling the four holes, remove the template and clean the drill holes.
the bolts through the mounting |
washers and then into the drilled |
holes. |
Fig,“;13
/ arrow
24
