FreparationofOven Drilling Approach
Remove Line Cord Holder A from the rear side of your oven. (Keep the screw for next step.) (Fig. 6)
Replace Line Cord Holder A with Line Cord Holder B using the screw and bundle the line cord. (Fig. 7)
Youhave two options for drilling the mounting holes for your microwave oven.
First, you can drill from inside of the cabinet if you have adequate space and your shelves are removable.
Second, you can drill from the bottom.
If possible, it is generally easier to work from the inside of the cabinet. Use the instructions applicable to the approach you select.
●If you have a partition in the cabinet, you must do the following:
1.Cut Template 2 into two pieces to fit each side of the partition.
2.Tape one piece of Template 2 inside the cabinet, making sure that the front edge is even with the front edge of cabinet.
3.Tape Template 1 on the front
of the cabinet so that the arrow is aligned with the hole center line on Template 2. (Fig. 10)
Buttons
Case Embosses
Instructions for Drilling from Inside
If you cannot drill from the inside, go to “Instructions for Drilling
From Bottom?
●If your cabinet is less than 12” deep, cut off the front edge of Template 2 the amount by which the cabinet depth is less than 12”. Use the template cut lines as a guide. Place Template 2 inside the cabinet. Cut around the door jam and the corners, if necessary, to make the template fit. (The front edge of template must be even with the front edge of the cabinet.) Use tape to keep it in place.
Fig. 10
40 Position remaining piece of Template 2 inside the cabinet and align the hole center lines with the arrowson Template 1 so that distance from right hole center to left hole center measures the distance indicated on the template. (You will have to cut excess paper from the middle of Template 2
to make it lay flat.) (Fig. 11)
( ’ ,
Fig. 8
Note: For cabinets with a recessed shelf you must measure the thickness of the front rail and cut that amount off the front edge of Template 2 using the template cut lines as a guide. This will allow Template 2
$
“w
Leftside
1.Carefully remove the four plastic plug buttons from the oven top
2.Locate the left side case emboss and place bracket so that the emboss fits into the
3.Locate the right side case emboss and place bracket next to the emboss. Replace screw and tighten securely.
to lay flat on the shelf. (Fig. 9)
7Front rail
Fig. 11 | of these holes |
5.Tape Template 2 inside the cabinet after cutting it to fit.
6.Check again to make sure that the hole center lines on Template 2 are straight and that the distance from the right to left drilling holes measures the distance indicated on the template.
7.Go to “Drilling the Mounting
Holes?
23