Safety Instructions |
Care and cleaning of the range.
Burner Caps and Heads (on sealed burners only)NOTE: Before removing the burner caps | Replacement | |
Replace burner heads over the electrodes | ||
and heads, remember their size and | ||
location. Replace them in the same | on the cooktop, in the correct locations | |
location after cleaning. | according to their size. | |
|
|
Operating | Instructions |
| |
Cleaning |
Use a sewing needle or
Lift off when cool. Wash burner caps
in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove
For proper ignition, make sure the small
hole in the section that fits over the electrode is kept open. A sewing needle or wire
The slits in the burner heads must be kept clean at all times for an even, unhampered flame.
Medium head |
|
|
|
|
|
|
|
|
| Small head | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Front of range
Medium head | Large head |
Care and | |
|
|
Installation | Instructions |
|
|
Troubleshooting | Tips |
|
|
Clogged or dirty burner ports or electrodes will not allow the burner to operate properly.
Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged.
You should clean the burner caps and burner heads routinely, especially after bad spillovers, which could clog the openings in the burner heads. Lift off when cool.
To remove
Before putting the burner caps and heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes.
NOTE: Do not use steel wool or scouring powders to clean the burners.
Make sure the slot in the burner head is positioned over the electrode.
Replace the matching size caps onto the heads. There is one small, two medium and one large cap. Sizes are stamped into the bottom of the caps.
Medium cap |
|
|
|
|
|
|
|
|
| Small cap | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Front of range
Consumer Support |
|
Medium cap | Large cap |
Make sure that the heads and caps are replaced in the correct locations.
NOTE: On some models, the burners are all the same size and power.
22