Installation Instructions
6LEVEL THE RANGE
AInstall the oven shelves in the oven and position the range where it will be installed.
7INSTALL THE ANTI-TIP DEVICE
WARNING —
Leg leveler
Raise | Lower |
range | |
| range |
Lower range
• If the |
does not fit this application, use the |
Device WB02k10020. |
• Range must be secured with an approved |
• Unless properly installed, the range could be |
Raise range
(on some models) | (on some models) |
BCheck for levelness by placing a spirit level or a cup, partially filled with water, on one of the oven shelves. If using a spirit level, take two
CRemove the broiler drawer or kick panel.
See the Care and cleaning of the range section. The front leveling legs can be adjusted from the bottom and the rear legs can be adjusted from the top or the bottom.
DUse an
EAfter the range is level, slide the range away from the wall so that the
tipped by you or a child standing, sitting or |
leaning on an open door. |
• After installing the |
it is in place by carefully attempting to tilt the |
range forward. |
• This range has been designed to meet all |
recognized industry tip standards for all |
normal conditions. |
• The use of this device does not preclude |
tipping of the range when not properly |
installed. |
AMark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.
device
Slotted head
screw
Wallplate Approx. 20°
21⁄ 8″ | Marked edge |
of range |
BLocate the outside edge of the device 21⁄ 8 ″ toward the center of the range from the marked edge of the range.
CUsing the device as a template, mark the position of the hole for the screw.
41
