GE JGBS19 When All Hookups Are Completed, INSTALL THE ANTI-TIP DEVICE cont

Models: JGBS19

1 52
Download 52 pages 30.67 Kb
Page 42
Image 42
7INSTALL THE ANTI-TIP DEVICE (cont.)

Installation Instructions

7INSTALL THE ANTI-TIP DEVICE (cont.)

DFor wood construction, drill a pilot hole at an angle of 20° from the horizontal. A nail or awl may be used if a drill is not available.

Mount the Anti-Tip device with the screw provided.

For cement or concrete construction, you

will need a 1/4x 112lag bolt and a 1/2O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

Wallboard

Back of

 

range

Anti-Tip

 

device

 

Wood screw

 

Install the sleeve anchor into the drilled

hole and then install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware.

ESlide the range against the wall, and check for proper installation by grasping the front edge of the cooktop and carefully attempting to tilt the range forward. The bracket should stop the range within 4 inches. If it does not, the bracket must be reinstalled.

WHEN ALL HOOKUPS ARE COMPLETED

Make sure all controls are left in the OFF position. Make sure the flow of combustion and ventilation air to the range is unobstructed.

CONVERT TO LP GAS (or convert back to natural gas from LP)

This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be performed by a qualified LP gas installer.

The conversion instructions and LP orifices can be found attached to the range next to the pressure regulator.

Keep these instructions and the orifices in case you want to convert back to natural gas.

42

Page 42
Image 42
GE JGBS19 When All Hookups Are Completed, INSTALL THE ANTI-TIP DEVICE cont, Installation Instructions