GE JGSP21GEP, JGSP20GEP manual Range Top Burners, To remove burners, To replace burners

Range Top Burners

—

	The holes in the burners must be
	kept clean at all times for proper
	ignition and an even, unhampered
	flame.
II	You should clean the burners
	routinely, especially after bad
	spillovers which could clog these
	holes. Burners lifl out for cleaning,
	Note: A screw holds each of the
	burners in place to keep them from
	wobbling around during shipment.
	Remove and discard the shipping
	screw.
	Burner

ShutterOrifice

To remove burners:

1.Grasp burner head and tilt it to the right to release the two tabs from slots in the burner support.

2.Lift the end of the burner assembly, then pull away from the front of the range to free the air shutter from the gas valve orifice.

To remove burned-on food, soak the burners in a solution of mild liquid detergent and wakr~ So~ the burners for 20 to 30 minutes. If the fmd doesn’t rinse off completely, scrub them with soap and water and a brush or plastic pad. Do not use steel wool or abrasive cleaners because they will clog the burner openings and scratch the burners. If the holes become clogged, clean them with a toothpick.

Do not attempt to clean burners in an automatic dishwasher. Loosene~ food soil can clog burner holes, and the caustic action of the dishwasher detergent can damage the burner heads.

Before putting the burners back, shake out excess water and dry them thoroughly by setting them in a warm oven for 30 minutes.

/ ‘“

CL Burner Support

e Air Shutter

To replace burners:

1.Slip the air shutter over the gas valve orifice.

2.Lower the burner assembly

and hook the tabs in the slots in the burner support.

3.Be sure both tabs are in their

slots, that the burner sits level and straight, and that the flash tube forms a straight line from the igniter to the burner.