Anti-Tip Device Installation Instructions for Kit No. 045 (344119)
Bracket
\
WARNING
●ALL RANGES CAN TIP
●INJURY COULD RESULT
●INSTALL
●SEE INSTRUCTIONS
Long Screw
\/
\
1.Before placing range in the counter, notice the location of the stability bracket which is already attached to the back of the range. This location should work
Make sure there are no structural supports for the countertop that will interfere with the stability bracket when located in the upper set of holes. Determine where the gas plumbing is located behind the range so the chain and bracket will in no way damage the plumbing.
2.Fasten one end of the stability chain to the floor or the wall with the long screw and washer supplied. Make certain the screw is going into the wall ulate at the base of the wall or one o~the studs in the wall (see Fig. 1). Whether you attach the chain to the wall or floor, be certain that the screw is in at least 3/4” thickness of wood other than baseboard and that there are no electrical wires or plumbing in the area that the screw could penetrate. Attach the stability chain in a location that will allow it to be in line with the bracket
3.Temporarily attach the loose end of the chain to the rear of the countertop with the tape from the packaging (see Fig. 1).
4.Place the range in the counter cutout leaving just enough room between the back of the range and the wall to reach the stability bracket.
5.Hook the loose end of the chain onto the bracket by slipping the nearest link of the chain into the slot in the bracket (see Fig. 2), making sure the chain is pulled as tight as possible and that there is no excess slack in the chain after chain is attached to the bracket.
Excess slack in the chain could allow the range to tip over excessively.
6.Slide the range all the way back into the counter cutout. Once the range is pushed back in dace. there will be a small amount df slack in the chain. This is normal.
28
