GE JGSP21GEP, JGSP20GEP Set the Oven for Cleaning, To Set a Delayed Start, To Stop a Clean Cycle

Set the Oven for Cleaning

The range must be completely cool in order to set the self-clean cycle.

1. Push the CLEAN button.

2.Turn SET knob in the clockwise direction about l/2 turn. The display will show “3:30?

The words “CLEAN TIME” will be displayed on the left. Within 20 minutes, the words “CLEAN LOCK” will be displayed on the right.

Note: You can find out when the clean cycle will be finished by pushing the STOP TIME button.

The word “DOOR” is displayed when you try to set a clean cycle with the door open or when the oven temperature is too high.

To Set a Delayed Start

1. Push STOP TIME button.

2.Turn SET knob to time of day when you wish cleaning to be

completed (must be more than 3% hours later than current time

of day).

3.Push the CLEAN button.

4.Turn SET knob in the clockwise direction about 1/2 turn.

The words “DELAY CLEAN” will be on in the display until the clean cycle starts. After the clean cycle starts, the word “CLEAN” will be on in the display.

Note: During a delayed self-clean operation, you can find out when the oven turns on by pushing and holding the CLEAN button.

To Stop a Clean Cycle

1.Press the CANCEL button.

2.Wait until the oven has cooled below locking temperature (about 20-30 minutes) and the word “LOCK” is off in the display.

You will not be able to open the door right away unless the oven temperature is at a safe level. If you cannot open the oven door immediately after the word “LOCK” goes off, wait one minute and try again.

After Self-Cleaning

1.When a clean cycle is finished, the word “CLEAN” will be off in the display.

2.Wait until the oven has cooled below locking temperature (about 20-30 minutes) and the word “LOCK” is off in the display.

You will not be able to open the door unless the oven temperature is at a safe level. If you cannot open the oven door immediately after the word “LOCK” goes off, wait about one minute and try again.

You may notice some white ash in the oven. Just wipe it up with a damp cloth.

If white spots remain, remove them with a soap-filled steel wool pad. Be sure to rinse thoroughly with a vinegar and water mixture. These deposits are usually a salt residue that cannot be removed by the clean cycle.

If the oven is not clean after one clean cycle, repeat the cycle.

(continued nextpage)

21