GEAppliances.com
Tones at the End of a Timed Cycle
Safety
At the end of a timed cycle, 3 short beeps will sound followed by one beep every 6 seconds until the CLEAR/OFF pad is pressed. This continual
To cancel the
Press the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows SF.
Press the KITCHEN TIMER ON/OFF pad. The display shows CON BEEP (continual beep). Press the KITCHEN TIMER ON/OFF pad again. The display shows BEEP. (This cancels the one beep every 6 seconds.)
Press the START pad.
Instructions Operating
If you would prefer to have a
Press the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows SF.
Press the CLOCK pad again to change to the
Press the CLOCK pad again to black out the clock display. The display will show OFF. If this is the choice you want, press the START pad.
Instructions
Press the CLOCK pad once. The | NOTE: If the clock is in the | |
display will show 12 hr. If this is | ||
will not be able to use the Delay Start function. | ||
the choice you want, press the |
| |
START pad. |
|
Care and
Cook and Hold
Your new control has a
To activate this feature, follow the steps below.
Press the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows SF.
Press the COOKING TIME pad. The display will show Hld OFF.
Press the COOKING TIME pad again to activate the feature. The display will show Hld ON.
Press the START pad to activate the
Cleaning Troubleshooting
Changing the Speed of the Increase or Decrease Pads
Tips
As you use the INCREASE or DECREASE pads when setting a time or temperature, you may notice the display changes slowly. This special feature allows you to change the speed.
To set the speed you prefer, follow the steps below.
Press the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows SF.
Press the INCREASE pad. The display will show you a set speed between
1 and 5.
Press the INCREASE pad to increase the speed up to the number 5.
Press the DECREASE pad to decrease the speed down to the number 1.
Press START to activate the setting and leave the control set in this special features mode.
13