GE JRP80 Using the clock and timer, Tips Care and, Cleaning Operating Instructions, Safety

Instructions

Using the clock and timer.

Safety

Make sure the clock is set to the correct time of day.

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle.

Press the CLOCK pad.

Press the INCREASE and DECREASE pads.

Press the START pad.

Cleaning Operating Instructions

The timer is a minute timer only.

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

To Set the Timer

Press the KITCHEN TIMER ON/OFF pad.

Press the INCREASE and DECREASE pads until the amount of time you want shows in the display. Maximum time that can be entered in minutes is 59. Cooking times more than

59 minutes should be changed to hours and minutes. For example, enter 90 minutes as 1 hour,

30 minutes.

If you make a mistake press the KITCHEN TIMER ON/OFF pad and begin again.

Press the START pad.

When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the KITCHEN TIMER ON/OFF pad is pressed.

The 6-second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.

Tips Care and

To Reset the Timer

If the display is still showing the time remaining, you may change it by pressing the KITCHEN TIMER ON/OFF pad and then pressing the INCREASE and DECREASE pads until the time you want appears

in the display.

If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by pressing the KITCHEN TIMER ON/OFF pad and then pressing the INCREASE and DECREASE pads until the time you want appears in the display.

Consumer Support Troubleshooting

To Cancel the Timer

Press the KITCHEN TIMER ON/OFF pad twice.

16