GE JTP10GS To Set the Clock, To Set the Timer, To Reset the Timer, To Cancel the Timer

Clock

The clock must be set for the automatic oven timing functions to work properly. The time of day cannot be changed during a Timed Bake or CLEAN cycle.

Timer

The timer does not

TIMER control oven ON/OFF operations. The

maximum setting on the timer is 9 hours and 55 minutes.

To Set the Clock

1.Press the CLOCK pad.

CLOCK

o

To Set the Timer

1.Press the TIMER ON/OFF pad.

2.Press the INCREASE or DECREASE pad to set the amount of time on timer.

The timer will start automatically within a few seconds of releasing the INCREASE or DECREASE pad,

The timer, as you are setting it, will display seconds until 1 minute is reached.

2.Press the INCREASE or DECREASE pad to set the time of day.

3.Press the CLOCK pad to start.

Then it will display minutes and seconds until 10 minutes is reached.

After 10 minutes, it will display minutes only until 59 minutes is reached.

After 59 minutes, it will display hours and minutes (“HR” now appears in the display) until the maximum time of 9 hours and 55 minutes is reached.

To Reset the Timer

If “TIMER” is showing, press the INCREASE or DECREASE PAD until desired time is reached.

If “TIMER” is not showing, press the TIMER ON/OFF pad first, then follow instructions above to set the timer.

To Cancel the Timer

Press and hold the TIMER ON/OFF pad until the word “TIMER” quits flashing on the display (about 4 seconds).

End of Cycle Tones

The end of cycle tone is 3 short beeps followed by

1 beep that repeats every 6 seconds until you press any operation. If you would like to eliminate the repeating beeps, press and hold the CLEAWOFF pad for 10 seconds.

To return the end of cycle tone to the repeating beeps, press and hold the CLEAWOFF pad for 10 seconds.

Display Messages

If “DOOr” appears on the display, the door is not closed. If “LOCK” appears on the display, the oven door is in the locked position. BAKE, BROIL and COOK TIME cannot be set if the door is in the locked position.

Power Outage

After a power outage, when power is restored, the display will flash and time shown will no longer be correct-for example, after a 5-minute power interruption the clock will be 5 minutes slow. The display flashes until the clock is reset. All other functions that were in operation when the power went out will have to be programmed again.

7