GE 164 D20~PO19 warranty Li@t Bulb Replacement, Groundi~ Imtructiom, Coohp Li@t in Hood, Oven Li@t

Li@t Bulb Replacement

Coohp Li@t in Hood Oven Li@t

Groundi~ Imtructiom

REMOVE SCREW

To replace cooktop light in hood, first disconnect fiwer at main fuse or circuit breaker panel or pull plug. Remove screw on right side of light compartment cover and lower cover until it stops.

Be sure bulbs to be replaced are cool before removing. Break the adhesive seal by gently unscrewing the bulbs. Replace with 40-watt incandescent bulbs (Part No. WB2X4253) available from your GE supplier. High intensity 40-watt bulbs (Part No. 40SllN/1) which are available in supermarkets and hardware stores may also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

To replace your oven light, first disconnect power at main fuse or circuit breaker or pull plug.

Remove the top grill by taking off 3 screws which hold it in place.

Next, remove the single screw located above door near center of oven that secures light housing. Remove bulb and replace with

a30-watt GE bulb (Part No. WB2X4235) available from your GE supplier. Secure light housing with screw.

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a power cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. (Fig. 1)

WARNING–improper

use of the grounding plug can result in a risk o~electric =hoc~.

		INSURE PROPER
		GROUND EXISTS
I	Fig. 1	BEFORE USE
I

Consult a qualified electrician or service technician if the groundin~ instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

Where a standard two-prong wall receptacle is encountered, it is your personal responsibility and obligation to have it replaced with

aproperly grounded three-prong wall receptacle.

Do not under any circ~ce cut or remove the third @round) prong from the power cord.

Do not use an adapter plug with this appliance.

Do not use an extension cord with this appliance.

29