GE JVM172K, JVM152K Light Bulb ~PLACEMENT, Exhaust FEATU~, Cooktop Ligh~ight Light, Oven Light

LIGHT BULB ~PLACEMENT

Cooktop Ligh~ight Light

To replace combination cooktop/night light, first disconnect power at main fuse or

circuit breakerREMOVE-SCREWpanel or pull plug.

With smoke and spatter shield (on model so equipped) in the OUT position, remove screw on right side of light compartment cover and lower cover until it stops.

Be sure bulbs	II I	I Ilull
to be replaced
are cool before
removing. Break
the adhesive
seal by gently		\
unscrewing the

bulbs. Replace with 40-watt incandescent bulbs (WB02X4253) available from your GE supplier. High intensity 40-watt bulbs (40S 11 N/l ), which are available in supermarkets and hardware stores, may also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

Oven Light

To replace your oven light, first disconnect power at main fuse or circuit breaker panel or pull plug. Remove the top grill by taking out the 2 screws that hold

it in place.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with

a30-watt incandescent bulb (WB02X4235), available from your GE supplier.

Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia maybe added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal. Wash the smoke

and spatter shield (on model so equipped) with a solution of warm water and detergent.

THE EXHAUST FEATU~

The exhaust hood feature on your microwave oven is equipped with

2 metal filters which collect grease. When the fan is operated, air is drawn up through the filters and is then discharged through the provided venting to the outside.

I METAL COOKTOP METAL

FILTER LIGHT FILTER

SMOKE & SPATTER SHIELD (On model so equipped)

34