GE JVM1790 Replacing the light bulb, and Cleaning, Cooktop Light/Nite Light, Plastic Color Panels

ge.com

CleanSteel

Use a clean, soft, light and lightly dampened cloth, then dry thoroughly. Do not use appliance wax, polish, bleach or products containing any chemical agent on the CleanSteel surfaces.

Plastic Color Panels

Use a clean, soft, lightly dampened cloth, then dry thoroughly.

Door Seal

It’s important to keep the area clean where the door seals against the microwave. Use only mild, non-abrasive detergents applied with a clean sponge or soft cloth. Rinse well.

Bottom

Clean off the grease and dust on the bottom often. Use a solution of warm water and detergent.

Replacing the light bulb.

Safety Instructions Operating Instructions Care

Remove screw.

Cooktop Light/Nite Light

Replace with a 120 volt, 40 watt (max.) halogen bulb. Order WB08X10051 from your GE supplier.

	To replace the cooktop light/nite light,
1
	first disconnect the power at the main
	fuse or circuit breaker panel, or pull
	the plug.
	Remove the screw from the side of the
2
	light compartment cover and lower the

cover until it stops.

3 Be sure the bulb is cool before removing. Break the adhesive seal by gently unscrewing the bulb.

4 Screw in the new bulb, then raise the light cover and replace the screw. Connect electrical power to the oven.

and Cleaning

Troubleshooting Tips Consumer Support

27