GE LP 33 - page 22

Modifications reserved Page 22/57

OPM_LPS_3UO_30K_40K_0US_V010.doc Operating Manual LP 33 Series 30 & 40 kVA

MAINS

f=60.0Hz

U1=120V U2=119V

U3=121V

1. Mains input voltage information screen.

2. Mains input frequency.

3. Mains line voltage L1 (A) and L2 (B)phases.

4. Mains line voltage L3 (C) phase.

RECTIFIER

f=60.0Hz

U1=120V U2=119V

U3=121V

1. Rectifier input vo ltage information screen.

2. Mains input frequency.

3. Input line voltage L1 (A) and L2 (B) phases.

4. Input line voltage L3 (C) phase.

INVERTER: U1=120V

U2=120V U3=120V

Frequency = 60.0Hz

Synchronized

1. Inverter voltage information screen.

2. Output inverter line voltage L1 (A), L2 (B) and L3 (C) phases

3. Output frequency.

4. Synchronization status inverter with respect to mains.

LOAD ON PHASE

U1=120V I1=56A 50%

U2=120V I2=50A 45%

U3=120V I3=61A 55%

1. Load on output phases information screen.

2. Voltage, current and load percentage phase L1 (A).

3. Voltage, current and load percentage phase L2 (B).

4. Voltage, current and load percentage phase L3 (C).

MISCELLANEOUS

Battery Temp. = +25°C

UPS Oper Time= 450h

INV Oper Time= 430h

1. Screen informing about the battery and time of operation.

2. Battery temperature.

3. Operating time (CPU powered) for the UPS (hours).

4. Operating time with inverter supplying the load (hours).

MAINS FAULTS STAT.

Minor = 100

Major = 150

Overloads = 30

1. Screen informing about the quality of the input power.

2. The quantity of bypass mains out of tolerance faults.

3. The quantity of rectifier mains out of tolerance faults.

4. The total number of detected output overloads.

IDENTIFICATION

LP 33 40kVA P1

SW Version: x.x

S/N: Q0040-0105-0001

1. Screen containing the data identifying the unit.

2. UPS family, nominal rating and for RPA: P + no. UPS.

3. The software version implemented on the control board.

4. The serial number of the unit.

ECO Mode RATE 100%

NR FAST TRANSIENT

<2ms >2ms >5ms >10ms

25 10 7 3

Screen containing the statistic evaluation in % (100= good; 0= bad)

of the utility, for the ECO Mode operation.

4. The number of fast transients occurred on the bypass utility on

the last seven days.

Contents

Main GE Consumer & Industrial Power Protection Operating Manual Uninterruptible Power supply LP 33 Series 30 & 40 kVA 208 VAC UL / Series 0 Page g Preface Safety instructions Parallel version secured with RPA Table of contents 1 SAFETY RULES THE ONLY CONDITION SAVE THESE INSTRUCTIONS Safety symbols and warnings 2 INTRODUCTION 2.1 GENERAL DESCRIPTION 3 DESCRIPTION 3.1 BLOCK DIAGRAM AND MAIN ELEMENTS DESCRIPTION 3.2 OPERATION MODES Page Page 3.3 RPA PARALLEL SYSTEM 3.4 UPS PARALLELED ON THE SAME BATTERY 3.5 SERVICE AND TECHNICAL SUPPORT g 3.6 RECYCLING AT THE END OF SERVICE LIFE 4 LAYOUT 4.1 LAYOUT LP 33 Series / 30 & 40 kVA 5 SYSTEM HANDLING 5.1 CONTROL PANEL 5.2 COMMAND PUSH BUTTONS AND SWITCHES 6 LCD SCREEN 6.1 METERING SCREENS (Metering) LP 33 40kVA P1 = 70% SERVICE REQUIRED Udcp=215V Udcn=215V Ubp=164V Ubn=164V O Charge Level = 100% Autonomy = 15min Page 6.2 EVENT SCREENS (Alarm) 01.01.2005 12:15:45 NR=255 Status=A588 4580: INVERTER AND MAINS SYNCHRONIZED 6.2.1 Alarms list Page Page 6.2.2 Messages list Page Page 6.2.3 Event report LP 33 Series LP 33 Series Description of repair action taken: Actual situation: Remarks: 6.3 MENU SCREENS (Menu) Page Tel1: Tel1 enabled: N Tel2: Tel2 enabled: N LCD Display UPS NAME: LP 33 Language = ENGLISH ECO Mode Y d1 d2 d3 d4 d5 d6 d7 HOURS SELECTED 24 24 12 12 12 12 12 Page Page 7 OPERATION 7.1 PROCEDURES FOR SINGLE LP 33 Series 7.1.1 Start-up of the LP 33 Series Page 7.1.2 UPS shutdown with load transfer on manual bypass (Q2) Page 7.1.3 Start-up following the operation on manual bypass (Q2) 7.1.4 Complete shutdown U2= 7V U3= 7V Frequency = 60.0Hz Synchronized 7.1.5 Restore to normal operation after total off 7.1.6 Restore to normal operation after EPO Emergency Power Off NR=255 Status=A588 4563: 7.2 PROCEDURES FOR PARALLEL SYSTEM LP 33 Series 7.2.1 Parallel System start-up of the LP 33 Series 7.2.2 Parallel UPS shutdown with load transfer on manual bypass (Q2) U2= 7V U3= 7V Frequency = 60.0Hz Synchronized 7.2.3 Start-up following the operation on maintenance bypass (Q2) any one of the units 7.2.4 Shutdown of a single unit in a parallel system 7.2.5 Start-up an additional unit in a parallel system 7.2.6 Complete shutdown of a parallel system 7.2.7 Restore to normal operation after total off 7.2.8 Restore to normal operation after EPO Emergency Power Off NR=255 Status=A588 4563: 8 OPTIONS 8.1 OPTIONS GENERAL VIEW 9 MAINTENANCE 9.1 GENERAL MAINTENANCE 9.2 COOLING FAN MAINTENANCE 9.3 BATTERY MAINTENANCE 9.4 SERVICE REQUIRED LP 33 40 kVA = 70% SERVICE REQUIRED 10 NOTES 10.1 NOTES FORM RIDER FOR WARRANTY FOR SALE OF SiteProTM, DIGITAL ENERGYTM SG Series and LP Series UPS.