GE LP 33 2 INTRODUCTION

Modifications reserved Page 9/57

OPM_LPS_3UO_30K_40K_0US_V010.doc Operating Manual LP 33 Series 30 & 40 kVA

2 INTRODUCTION

2.1 GENERAL DESCRIPTION

The LP 33 Series Uninterruptible Power Supply (UPS) provides the energy supply for critical loads which

need a reliable, continuous free from voltage disturbances and frequency fluctuations supply.

In case the mains fails, or it exceeds the permitted tolerances, the energy to supply the load is furnished

by the battery with a backup time dependent on its capacity, until the mains recovers.

LP 33 Series is a truly VFI double conversion Uninterruptible Power Supply (UPS),

equipped with automatic bypass, where the load is normally supplied by the inverter.

LP 33 Series can be configured, if chosen, for the ECO Mode permitting the maximum

energy saving.

The main typical performances of the LP 33 Series system are the following:

• VFI (Voltage Frequency Independent) double conversion technology to provide an excellent

quality power supply.

• Input power factor 0.8.

• Input current THD <10%.

• Automatic bypass and manual bypass to improve reliability and maintenance.

• Microprocessor controlled supervision.

• Dual AC inputs (optional).

• ECO Mode operation.

• Compact and agreeable design expressly conceived for “Office environment”.

• Low level acoustic sound, 50 dB(A) (10 kVA), 55 dB(A) (20 kVA) and 61 dB (A) (30 & 40 kVA) to avoid

noise to the persons operating in the same environment.

• Multi-language LCD screen.

• Total battery management: SBM (Superior Battery Management)

• High battery capacity, 22 minutes (10 kVA), 9 minutes (20 kVA), 29 minutes (30 kVA) and 19

minutes (40 kVA), with battery housed in the UPS cabinet.

• Wide rectifier input voltage tolerance: 152 ÷ 240 VAC (phase – phase).

• Wide rectifier input frequency tolerance: +/-10% (54 ÷ 66 for 60 Hz).

• RPA (Redundant Parallel Architecture) up to 4 units.

• GE Connectivity.

• Compliance with UL standard 1778.

Contents

Main GE Consumer & Industrial Power Protection Operating Manual Uninterruptible Power supply LP 33 Series 30 & 40 kVA 208 VAC UL / Series 0 Page g Preface Safety instructions Parallel version secured with RPA Table of contents 1 SAFETY RULES THE ONLY CONDITION SAVE THESE INSTRUCTIONS Safety symbols and warnings 2 INTRODUCTION 2.1 GENERAL DESCRIPTION 3 DESCRIPTION 3.1 BLOCK DIAGRAM AND MAIN ELEMENTS DESCRIPTION 3.2 OPERATION MODES Page Page 3.3 RPA PARALLEL SYSTEM 3.4 UPS PARALLELED ON THE SAME BATTERY 3.5 SERVICE AND TECHNICAL SUPPORT g 3.6 RECYCLING AT THE END OF SERVICE LIFE 4 LAYOUT 4.1 LAYOUT LP 33 Series / 30 & 40 kVA 5 SYSTEM HANDLING 5.1 CONTROL PANEL 5.2 COMMAND PUSH BUTTONS AND SWITCHES 6 LCD SCREEN 6.1 METERING SCREENS (Metering) LP 33 40kVA P1 = 70% SERVICE REQUIRED Udcp=215V Udcn=215V Ubp=164V Ubn=164V O Charge Level = 100% Autonomy = 15min Page 6.2 EVENT SCREENS (Alarm) 01.01.2005 12:15:45 NR=255 Status=A588 4580: INVERTER AND MAINS SYNCHRONIZED 6.2.1 Alarms list Page Page 6.2.2 Messages list Page Page 6.2.3 Event report LP 33 Series LP 33 Series Description of repair action taken: Actual situation: Remarks: 6.3 MENU SCREENS (Menu) Page Tel1: Tel1 enabled: N Tel2: Tel2 enabled: N LCD Display UPS NAME: LP 33 Language = ENGLISH ECO Mode Y d1 d2 d3 d4 d5 d6 d7 HOURS SELECTED 24 24 12 12 12 12 12 Page Page 7 OPERATION 7.1 PROCEDURES FOR SINGLE LP 33 Series 7.1.1 Start-up of the LP 33 Series Page 7.1.2 UPS shutdown with load transfer on manual bypass (Q2) Page 7.1.3 Start-up following the operation on manual bypass (Q2) 7.1.4 Complete shutdown U2= 7V U3= 7V Frequency = 60.0Hz Synchronized 7.1.5 Restore to normal operation after total off 7.1.6 Restore to normal operation after EPO Emergency Power Off NR=255 Status=A588 4563: 7.2 PROCEDURES FOR PARALLEL SYSTEM LP 33 Series 7.2.1 Parallel System start-up of the LP 33 Series 7.2.2 Parallel UPS shutdown with load transfer on manual bypass (Q2) U2= 7V U3= 7V Frequency = 60.0Hz Synchronized 7.2.3 Start-up following the operation on maintenance bypass (Q2) any one of the units 7.2.4 Shutdown of a single unit in a parallel system 7.2.5 Start-up an additional unit in a parallel system 7.2.6 Complete shutdown of a parallel system 7.2.7 Restore to normal operation after total off 7.2.8 Restore to normal operation after EPO Emergency Power Off NR=255 Status=A588 4563: 8 OPTIONS 8.1 OPTIONS GENERAL VIEW 9 MAINTENANCE 9.1 GENERAL MAINTENANCE 9.2 COOLING FAN MAINTENANCE 9.3 BATTERY MAINTENANCE 9.4 SERVICE REQUIRED LP 33 40 kVA = 70% SERVICE REQUIRED 10 NOTES 10.1 NOTES FORM RIDER FOR WARRANTY FOR SALE OF SiteProTM, DIGITAL ENERGYTM SG Series and LP Series UPS.