Care and cleaning. | ge.com |
Safety
Cleaning the Outside
IMPORTANT: Unplug the beverage center or wine chiller before cleaning.
Keep the outside clean. The cabinet can be washed with mild soap and water. Rinse thoroughly with clean water. Never use abrasive scouring powders.
Use a glass cleaner or mild soap and water and a soft cloth to clean the glass door. Do not use any abrasive powders.
Wipe the controls with a damp cloth. Dry thoroughly. Do not use cleaning sprays, large amounts of soap and water, abrasives or sharp objects on the
Do not wipe the beverage center or wine chiller with a soiled dishcloth or towel.
These may leave a residue that can
erode the paint. Do not use scouring pads, powdered cleaners, bleach or cleaners containing bleach because these products can scratch and weaken the paint finish.
Stainless steel. Regularly clean and polish the stainless steel areas (on some models) with a commercially available stainless steel cleaner such as Stainless Steel Magic® to preserve and protect the fine finish. Stainless Steel Magic® is available through GE Parts and Accessories, 800.626.2002, or ge.com. Order part number WX10X15.
Do not use appliance wax or polish on the stainless steel.
Instructions
Instructions | Operating |
Cleaning the Inside
IMPORTANT: Unplug the beverage center or wine chiller before cleaning.
The vinyl door gasket may be cleaned with mild soap and water or a baking soda solution. Rinse well.
After cleaning the door gasket, apply a thin layer of paraffin wax or petroleum jelly to the door gasket at the hinge side. This helps keep the gasket from sticking and bending out of shape.
Use a slightly damp cloth or sponge when cleaning around switches, lights or controls.
Use warm water and baking soda solution— about a tablespoon (15 ml) of baking soda to a quart (1 liter) of water. This both cleans
and neutralizes odors. Thoroughly rinse and wipe dry.
Other parts of the beverage center or wine chiller
Avoid cleaning cold glass shelves with hot water because the extreme temperature difference may cause them to break. Handle glass shelves carefully. Rough handling of tempered glass can cause it to shatter.
Do not use detergents, scouring powders, spray cleaners or other harsh chemicals to clean the interior.
Installation
Cleaning
Instructions
Drain hole
Drain Hole
Periodically check the drain hole and channel for any debris. If the drain is blocked, condensation will not drain properly.
To check and clean the drain hole, remove the bottom two glass shelves or bottom two full extension drawers. Sweep a damp cloth along the channel in the back of the beverage center. Use a finger to sweep away any debris from the drain hole.
Troubleshooting Tips
Light Bulb Replacement
Unplug the beverage center or wine chiller | To remove the light shield, push in the tab on |
before replacing the light bulb. | the left side of the shield and lower it. Replace |
| with a 15 watt appliance bulb. |
In the Event of a Power Failure
If the power fails, open the door as | Do not store or use gasoline or other |
|
infrequently as possible to maintain | flammable vapors and liquids in the vicinity | |
the temperature. | of this or any other appliance. | 7 |
Consumer Support