GE PCR06BATSS Controls and features-Beverage Center, Safety, Operating, Instructions, Consumer

Models: PCR06WATSS PCR06BATSS

1 64
Download 64 pages 21.19 Kb
Page 4
Image 4
Controls and features—Beverage Center.

Instructions

Controls and features—Beverage Center.

Temperature Control

Safety

 

 

Operating

Instructions

 

 

The operating temperatures of the beverage center range from the low forties to the mid fifties. This appliance is not a refrigerator and does not maintain temperatures like a refrigerator (below 41°F).

Do not install the beverage center where the temperature will go below 55°F (13°C) or above 90°F (32°C).

As with any refrigeration-type product, there is a slight temperature variance at different locations within the cabinet.

The coolest area will be in the lower part of the cabinet.

The cooler area will be in the middle section.

The upper part of the cabinet is the warmest section.

When the temperature is adjusted, allow 24 hours for the unit to stabilize.

To set the control, turn it to the midpoint setting (approximately 45ºF). Once the beverage center is loaded, allow at least 24 hours before making any adjustments to the initial setting.

NOTES:

This unit is designed for storing and cooling beverages. It is not intended for the storage of perishable foods.

The lowest temperatures are found on the lower shelves/racks and toward the rear of the shelves/racks.

Care and Cleaning

 

Installation Instructions

To remove, lift up on the back of the shelf

Glass Shelves

Tempered glass shelves in the beverage center unit are removable for easy cleaning or for storing larger items.

To remove a shelf, open the door completely to avoid potential damage to the gasket. Lift up on the back of the shelf slightly. Tilt the shelf to one side at an angle while pulling forward.

To replace a shelf, open the door completely to avoid potential damage to the gasket. Tilt the shelf to one side at an angle and slide toward the back wall, placing one side onto the shelf support. Place the other side onto the opposite shelf support. Ensure rear locking tabs are engaged. When installed properly, the shelf will not slide forward when gently pulled.

Tips

Support

Troubleshooting

Tilt the shelf at an angle while removing or replacing

Place in slots when replacing the shelf

Consumer

Bottom drawer arrangement

Loading Tips and Suggestions

• The bottom two full extension drawers hold six bottles each and are loaded with necks facing the rear. Tall bottles should not be loaded on the bottom drawer because they may prevent the door from closing.

Do not allow children to climb, stand or hang on the beverage center shelves or full extension drawers. They could seriously injure themselves and possibly cause damage to the beverage center.

4

Page 4
Image 4
GE PCR06BATSS, PCR06WATSS Controls and features-Beverage Center, Safety, Operating, Instructions, Tips Support, Consumer