Installation Instructions
THE INSTALLATION SPACE
The beverage center and wine chiller can be a
| Locate |
|
| Outlet |
|
|
| |
9" Max. |
| |
| ||
| 24" Min. | |
|
| |
Product dimensions: |
|
|
Height: |
|
|
Width: |
| |
Depth: |
| |
|
|
Height:
Width: 24″ (610 mm) minimum
″23-3/4"Depth: 24 (610 mm) minimum
The cutout depth should be 24″
The cutout dimensions shown allow for a full door swing and access to the
•The door should protrude
cabinets. For easy reference, the back edge of the pocket handle should protrude a minimum of 5/8″ beyond the front edge of the countertop.
•If installing between frameless cabinets, a 1/2″ wide filler strip or side panel may be needed on hinge side. The filler strip will act as a spacer between the case and adjacent cabinet door swing. The width of the opening
must include the filler panels. NOTE: The door should protrude
•The beverage center and wine chiller can be installed freestanding.
Additional Specifications
•A 120 volt 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded
SIDE-BY-SIDE INSTALLATIONS
Increase storage capacity by installing two beverage centers or wine chillers together. Or, for a complete refreshment center, install any two of these units together.
•A
•Products must operate from separate, properly grounded receptacles.
| Locate | |
| Outlet | |
| ||
9" | 9" | |
| 15" | |
|
| |
|
9