GE PDW7000 Series Before you call for service…, Cleaning the Control Panel, Troubleshooting Tips

Models: GLD6900 Series PDW7000 Series

1 32
Download 32 pages 10.54 Kb
Page 12
Image 12
Cleaning the Control Panel

Instructions

Caring for the dishwasher.

Cleaning the Control Panel

To clean the control panel, use a lightly dampened cloth. Then dry thoroughly.

Safety

Protect Against Freezing

If your dishwasher is left in an unheated place during the winter, ask a service technician to:

1Cut off electrical power to the dishwasher. Remove fuses or trip circuit breaker.

2Turn off the water supply and disconnect the water inlet line from the water valve.

3

4

Drain water from the water inlet line and water valve. (Use a pan to catch the water.)

Reconnect the water inlet line to the water valve.

Operating Instructions

Air gap

Check the air gap any time your dishwasher isn’t draining well.

Does Your Dishwasher Have an Air Gap?

An air gap protects your dishwasher

The air gap is easy to clean.

against water backing up into it if a drain

 

 

Turn off the dishwasher and lift off the

clogs. The air gap is not a part of the

 

1

dishwasher. It is not covered by your

 

 

cover.

 

 

 

 

 

warranty. Not all plumbing codes require

 

 

Remove the plastic cap and clean with

 

2

air gaps, so you may not have one.

 

 

 

a toothpick.

 

 

Troubleshooting Tips

Consumer Support

Before you call for service…

Troubleshooting Tips

Save time and money! Review the charts on the following pages, or visit www.geappliances.ca. You may not need to call for service.

Error Messages

Possible Causes
What To Do

START/RESET status

You have pressed the

Press the START/RESET pad once to start the dishwasher. Press the

indicator light flashing START/RESET pad while the

START/RESET pad a second time when the dishwasher is running only if you

 

dishwasher is running. This will

wish to cancel the cycle.

 

cancel the cycle. The light will

 

 

stop flashing after the dishwasher

 

drains (about 90 seconds).

 

 

 

Power to the dishwasher was

The light will stop flashing after the dishwasher drains. A new cycle will

 

turned off while a cycle was

start automatically.

 

running and power has just been

 

 

restored to the dishwasher. The

 

 

blinking lights indicate that the

 

 

dishwasher is draining the potential

 

 

water inside.

 

Dishwasher BEEPS
This is a reminder that your
Close and latch the door after opening it mid-cycle.

once every 30 seconds dishwasher door has been left open during operation. It will continue beeping until you close the door.

12

Page 12
Image 12
GE PDW7000 Series Before you call for service…, Cleaning the Control Panel, Protect Against Freezing, Troubleshooting Tips